| Garage Door Brace |
|
|
|
|
PATENTED VERTICAL BRACING SYSTEM FOR GARAGE DOORS Secure Door® is an extremely effective, Florida Building Code approved (FL6420), highly affordable solution that provides wind protection for garage doors in the event of a major hurricane. The product is a vertical bracing system made from high quality aircraft-grade aluminum that attaches to the inside of the garage door. Secure Door® hurricane garage door protection strengthens the door and provides support for the door in addition to the garage door tracks. Secure Door® is a patented hurricane garage door brace that converts most existing garage doors to a hurricane-resistant garage door. While no garage door can be considered a hurricane proof garage door, Secure Door’s exceptional performance capabilities have been proven through independent laboratory tests and may be as close to that goal as possible.
Hurricane protection without replacing your existing garage door A Secure Door® vertical brace is pictured below on the inside of a typical 70 mph non-wind loaded steel door.
Once the initial installation is complete, Secure Door® is removed until needed. When not in use, only the top bracket (attached to the wall above the garage door) and the bolts for the floor anchor remain permanently in place. The floor anchor bolts fit flush and inconspicuously out of the way on the garage floor. After the initial installation is complete, each Secure Door® brace can be put in place should a hurricane threaten (and subsequently taken down) in less than three minutes.
Want to Do It Yourself? Secure Door® is designed for do-it-yourself installation by most homeowners. Set up and installation requires an electric drill, a ½" masonry bit, a 5/16 inch socket driver, a crescent or socket wrench, a hammer, scissors or utility knife, and a single blade screwdriver. The set-up and installation of the first brace typically can be completed in about 45 minutes with additional braces taking less time. A handyman or service can be hired usually at a very reasonable cost if the homeowner does not wish to install the brace(s) St Augustine Aluminum Co. aka Atlantic Hurricane Protection can install the product for you. The DIY price is $159.99 per brace plus tax. Click Here to view the Installation instructions The Installed price is $230.00 per brace. Call Now to schedule a FREE in home ESTIMATE
829-5422 |
|||||





